Week 7
May 18, 2018
Our goals this week are to:
This week the team primarily focused on applying primer to the cube and painting it, completing the printing of the house, and beginning the printing of the bus.
3 pieces of the bus were printed. The remaining ones will be ready by next week.
The puzzle cube was also completely coated with the XTC-3D to prepare it for priming. Damaged pieces were reprinted, coated and assembled. Next we will apply the white primer, to not only give it a more uniform look, but also prepare it for painting.
Our goals this week are to:
- Print entire House set and glue the magnets
- Tape the 10x10x10 cm Cube set and get it ready for priming and painting
- Start printing the bus model
This week the team primarily focused on applying primer to the cube and painting it, completing the printing of the house, and beginning the printing of the bus.
3 pieces of the bus were printed. The remaining ones will be ready by next week.
Figure 1: The first 3 pieces of the Bus set.
The puzzle cube was also completely coated with the XTC-3D to prepare it for priming. Damaged pieces were reprinted, coated and assembled. Next we will apply the white primer, to not only give it a more uniform look, but also prepare it for painting.
Figure 2: 10x10x10 cm cube coated with XTC-3D and ready for priming.
We used masking tape to cover the inner faces of each piece in the puzzle cube. This is so that the inner faces are colored when the white primer and colored paint are applied.
Figure 3: Taped Pieces of 10x10x10 cm Cube
Comments
Post a Comment